[China Glass Network] With the development of science and technology, the application of new glass is more extensive than traditional glass, and the patterns are also particularly variable, such as flooring. Of course, the new glass also has advantages and disadvantages, but a lot of friends are not particularly aware of it, today we will come to understand the knowledge of new glass, I hope to help everyone. SHAOXING OCEAN CO., LTD , https://www.sxgarments.com
First, the introduction of new glass 1, titanium glass
Compared with traditional glass, titaniumized glass has good crush resistance and maintains its original shape under high temperature and high heat. The product is colorless, transparent, brown, copper and so on for consumers to purchase.
2, heat absorption glass
This glass product can meet the needs of consumers in the warm winter and cool in summer. In summer, it can absorb the visible light of the sun, weaken the intensity of indoor sunlight, and absorb a certain amount of ultraviolet light. In winter, it can isolate the cold air outside. It achieves the function of warm winter and cool summer.
3, glass ceramic
Compared to conventional glass, the atoms of glass-ceramics are ordered crystals, so they have the same brightness as ceramics and are tougher than glass.
Second, the advantages and disadvantages of new glass flooring
The glass floor is mainly a kind of floor which is made up of high-strength glass supported by modern technology. It has a different feeling compared with the traditional wooden floor.
The main raw material of the glass floor is silica, which can be seen everywhere in nature. Therefore, the cost of the glass floor is relatively low, and the difference between the glass floor and the wooden floor is that it does not need to destroy the trees in nature and is more environmentally friendly. The glass floor is more convenient to handle because it is made of glass. Therefore, the glass floor will not have the same anti-corrosion and fear of insects as the floor made of natural materials such as wood flooring and bamboo flooring. It can also be cleaned directly with water, making it easier to clean and manage than wood flooring.
Of course, glass flooring cannot be an advantage without disadvantages. Glass flooring has not been widely used as a new type of flooring. The defects are also obvious.
Glass is the chief culprit of light pollution. Whether the glass floor we lay in the room will cause serious light pollution to our room is a topic worth exploring. After the glass floor is scratched, can it be replaced? If it can't be replaced, the performance of the glass floor will definitely be reduced a lot. Compared with the practical performance of the wooden floor, the glass floor is definitely a lot worse in the sense of the foot, which is also a problem that many consumers wait and see.
Third, glass floor decoration methods and precautions
Be sure to purchase a suitable glass floor before making renovations. Be sure to note that there should be no cracks on the glass.
1. The floor where the glass floor is laid must be level and clean.
2. Before the construction, it is better to lay the glass floor on the flat floor for more than 24 hours. The temperature of the construction site is better at about 15 °C. When cutting the glass, leave more than 5 cm at both ends.
3. Before pasting, roll the unfolded floor back about halfway, then the glass floor will be scraped from the middle (using a toothed scraper to scrape the glue).
4, in the laying process to align the site line, the floor is better numbered, not easy to make mistakes during construction.
5. Add the special connecting belt specially designed by the manufacturer when purchasing the floor at the joint of the two glass floors, put it on the lower side of the joint, and then brush the glue on the connecting belt. This step is to ensure that the two floors are as close as possible. It is recommended to use water-soluble glue, which is less harmful to the human body.
6. Use cork board to evenly squeeze the floor surface from the middle of the floor to the sides, so that the surface of the floor is smooth and free of air bubbles, and it is completely rolled flat afterwards.
7. After the glass floor is well bonded, it should be slotted and welded. Note that the welding line should be leveled after welding.
Do you know the advantages and disadvantages of glass flooring?